#arpnetworks/ 2018-05-11,Fri

↑back Search ←Prev date Next date→ Show only urls(Click on time to select a line by its url)

WhoWhatWhen
***dne has joined #arpnetworks [00:24]
............................................................................................. (idle for 7h41mn)
gizmoguy has quit IRC (Ping timeout: 276 seconds)
gizmoguy has joined #arpnetworks
[08:05]
..... (idle for 24mn)
ziyourenxiang has joined #arpnetworks [08:29]
................................................................................ (idle for 6h35mn)
anis has quit IRC (Changing host)
anis has joined #arpnetworks
anis is now known as anisfarhana
[15:04]
anisfarhanaHello folks! [15:05]
......................... (idle for 2h1mn)
***hive-mind has quit IRC (Ping timeout: 250 seconds)
hive-mind has joined #arpnetworks
[17:06]
.................... (idle for 1h36mn)
mercutiohi anisfarhana [18:42]
anisfarhanaHi mercutio [18:42]
mercutiothings have been quiet in here [18:42]
anisfarhanaI love arpnetworks.
and garry is handsome
[18:42]
...................................... (idle for 3h8mn)
johnny-ois anyone else on kct01? i was migrated from kvr26 (RIP), and since then it seems disk I/O has been much worse than it was on kvr26. i'm using openbsd 6.3 on this one.
not sure what the differentiator is
bonnie++ with defaults has taken about 15 minutes on consecutive runs
this is on an "all-purpose" level VPS
[21:50]
........... (idle for 52mn)
mercutiojohnny-o: openbsd has some issues that forces synchronous disk i/o :(
the only workaround i've found so far is sending a scsi cache flush
but because openbsd isn't sending cache flushes to the disk it defaults to writing synchronously rather than asychronously
it's worse with openbsd 6.2/6.3 than 6.1 though
i'm not sure of the reason for that
scsi -f /dev/rsd0c -c "35 0 0 0 64 0"
that's the command i used that fixed the speed, quite hackish, but there is potential for data loss
as it won't send subsequent flushes
not even typing "sync" sends a cache flush
[22:46]

↑back Search ←Prev date Next date→ Show only urls(Click on time to select a line by its url)